SUPERTHIN PLATFORM SCALE
Thank you for purchasing this latest model platform scale. Please read the instructions carefully before using to achieve the optimum results.
IMPORTANT
POWER REQUIREMENTS
This scale operates a built in battery, such battery has been fully charged before shipment.
Charging: use the USB connecting wire(included), connect Scale and any kinds of MICRO USB CHARGING .
INPUT:such as: car charger, mobile plug, computer USB interface,power Bank, USB Socket.Normally, charging time around 3 hours(red light will light up), such red light will auto cutoff after battery fully charged.
FUNCTION KEYS OPERATION
“ON/OFF”: Switch power function key.
(1)When the scale is shutdown, press the“ON/OFF” key to turn on the scale, and the LED screen will display “0 kg”or “0 lb” or “0 oz”,and the scale will enter the weighting mode.
(2)When the scale is turned on, press the “ON/OFF” key to turn off the scale.
“TARE”: Reset the scale readout to zero key.
Press the “TARE”key will reset the scale readout to zero.
“MODE”: Units and mode change key.
(1) When the scale is under the weighting mode, press the “MODE” key will display different weighting units, and these units include “kg”or ”lb” or “lb_oz”.
(2) When the scale is under the counting mode, press the “MODE” key will enter the weighting mode.
“PCS”: Pieces counting function key.
(1)When the scale is under the weighting mode, press the “PCS” key can enter the counting mode. In the meantime, press the “PCS” key different times, the LED screen will display “PC-25” or “PC-50”or “PC-100”, which means that the numbers of the sample objects should be 25 or 50 or 100.
(2)After choosing a certain number of the sample objects, put the chosen number of the sample objects on the weighting platform, then press the “PCS” key again.Wait for the LED screen to display the number of sample objects, then take the sample objects from the platform.
(3)After the LED screen displays “0 pcs”, put similar weight objects on the platform to count the total number of pieces.
Calibration Instructions
This scale had been calibrated before it was dispatched from the factory. But at times when there is a remarkable change in temperature or humidity (including change of seasons), there might be inaccuracies. In this case, please test the scale in the following way: place a standard weight on the platform, and if the positive or negative difference exceeds the difference allowed as specified in the technical specifications of the weight, please recalibrate the scale according to as follows.
Recalibration steps: Use your left hand finger press down the “MODE” button(don’t release),use your right hand finger press down “ON/OFF” BUTTON, Release two fingers together until the LED screen show: “CAL 100”,press “MODE” button again will show: CAL 25 –again-CAL 50-again-CAL 100, this is to mean: place a calibration weight: 25kg, 50kg, 100kgs,depend on your option, any calibration weight(25,50,100kgs) place on the middle of platform, the LED screen will show:“GOOD”that is to mean: calibration is over.
Technical specifications
Max.capacity & readability in Different Units:
200 kg / 0.05 kg 440 lb / 0.1 lb 440 lb / 1 oz
Trouble – shooting
“H”: The scale has exceeded its weight limit and will not register an accurate reading.
“ ”: Too low battery power, there need to recharged the battery.
designation | quantity | explain |
scale | 1 |
|
power line | 1 |
|
specification | 1 |
|
adjusting screw | 4 |
|
Packages
HPC-200 :