CN3065 超小单节锂电池太阳能充电板

这是一款基于CN3065的超级迷你太阳能充电器。它能够从太阳能电池板或其他光伏设备中获取最大可能的电能并给锂电池充电。使用非常简单，只需将太阳能电池板插入到太阳能充电器的输入端，将可充电锂电池插入到电池输入接口，即可开始充电！

太阳能充电器的输出旨在为单个聚合物锂离子电池充电。负载应与电池并联。默认情况下，太阳能充电设置的最大充电电流为500mA，最大推荐输入充电电压为6V（最小4.4V）。

特征：

重量：5g

太阳能电池板输入：4.4-6V

最大充电电流：500Ma

接口：2针JST连接器（或PH2.0）

短路保护

自动再充电

连续充电电流高达500mA

电池状态指示（红色：充电，蓝色：已充电）

微型USB连接器

尺寸：2厘米x 4厘米

This is a super mini Solar Lipo charger based on the CN3065 - a single lithium battery charge management chip.

This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging!

The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It’s recommended that batteries not be charged at greater than their capacity rating.

Features:

Solar panel input: 4.4-6V

Max charge current: 500Ma

Interface: 2-pin JST connectors(or PH2.0)

Short circuit protection

Continuous Charge Current Up to 500mA

Battery status indication ( Red : Charging , Blue: Charged )

Micro-USB Connector

Size: 2cm x 4cm